Rocker stud torque spec?

[Otis!]

Anybody have it, or know where to look for it? I searched Canfield's site, cause I thought it was there, but, but...

Anybody have TFS instructions?

Help an old fat fellar out, por favor!

O!

[Otis!]

Found the TFS instructions on-line; 55 ft-lbs...

Thanks!

/me goes back to the garage...

[89LX306]

Sounds like you've been working in the same area I was today.

I have successfully become lazier than before. I managed to R&R the lower intake with the Thermostat housing still bolted on and the distrubutor in and my main wiring bundle under the firewall seam. It required a couple of dislocated joints but I got it in there.

Sidenote: Drill bits make good locating pins for the lower intake when your gaskets won't sit still.

Hope all is going better for you this round Nay.

[Otis!]

Seems to be Mr. Mickleserson. I got the heads on and torqued, headers on and tightened, rockers on and ran, and started bolting on the accessories when I discovered thise CrAzY New Zealanders (aka Kiwi's) didn't copy the bolt pattern very well. Drilling the bracket holes oversized allowed them to fit though, so problem resolved...

I hope yours goes well, and you get it running. I 'might' be able to fire mine Friday (since I'm off); we shall see...

Nay!, er, O!