wolfe race craft rear set up how to check

[jeremy mifflin]

ok the rear is under the car i set the upers and lowers to be the same as stock ......what do i need to do to make sure the rear in in the car right and not twisted...............

[TxBandit]

When I put the rear in my car I had it on jack stands and found four good reference points. Two near the front of the car and two on the rearend housing. I used the point where the front frame rail attached to the core support in the front and the shock mount on the housing. I then hung a plumbob and made a mark on the floor at each of the four points. Then I measured diagonally between the points and adjusted the housing as needed to make it square.

Be sure that you only use the lowers to get the housing square. Then use only the uppers to set pinion angle or preload or whatever you chose.

Troy

[jeremy mifflin]

that does not sound to bad...thanks i will give it a try