Question bout my NOS set-up

[HoustonLX]

I have a question about something I just thought about. If you have been reading my "Hell has frozen over" post, you know the nitrous set-up I plan on running. The question I have is this...

When on the 2-step, what will prevent the nitrous from activating? I don't see how the Digital 6 has control over that. I will be running the 2-step off a button. Is there a way to not only have the button control the 2-step, but also keep the nitrous from activating when pressed?

[FE_rex]

Use a NC relay to interrupt the sytem when the button is pushed.

NC - Normally closed

[red95gts]

Yep...that would be the best way to do it. As far as I know, the Dig 6 will not stop the N2O from activating (I'm assuming you are running a WOT switch on the kit).

If you need some help wiring it up, let me know and I'll make you a diagram in MS Paint and send it your way...

[red95gts]

One more thought...

If you are running a window switch and you set the 2-step lower than the window....you wouldn't need to run the relay...

[HoustonLX]

Originally posted by red95gts
One more thought...

If you are running a window switch and you set the 2-step lower than the window....you wouldn't need to run the relay...

But what if I lauch at 5k rpm's? :D

I will probably go the NC relay route. Thanks Ken.

[red95gts]

Originally posted by HoustonLX
But what if I lauch at 5k rpm's? :D


BOOM BITCH!

:D