View Full Version : Me too.. New 1/8th best...
Frank5L
10-14-2002, 11:10 PM
1.969 60'
5.574 330'
8.526@84.58 660'
track is actually 1000'
10.898@94.95 1000'
best 1000' was next pass though
10.896@95.52 w/ 2.03 60'
72degrees 75% humidity
Thats at full weight (only thing out of the truck is the jack from under the pass seat, and tools out of behind-seat compartment, and my trailer hitch receiver "insert") Probably about 5000lbs
HoustonLX
10-14-2002, 11:27 PM
Very nice Frank. Time to put some real tires on it and see what the heavy weight will do. :D
Frank5L
10-15-2002, 12:04 AM
YUP :D
HoustonLX
10-15-2002, 06:37 PM
Frank, here is some times from a guy with a new lightning at the event I was at Sat.
dial 8.15
60' 1.83
330 dont remember
1/8th 8.17
mph 85.2mph
His MPH is similar to yours, only he was on Hoosiers I think. In his sig, he has 12.96 at 101 MPH. This should give you an idea of what you might run with some REAL tires. ;) :D
Frank5L
10-18-2002, 01:56 AM
Ran it at Memphis tonite.
best pass was:
.563 r/t
2.010 60'
5.568 330'
8.477@84.64 660' (best mph of night was 85.15)
11.018 1000'
13.181@104.14 1320' (best mph was 105.25)
While this is a best 330, 660' E/Ts, the 60, 1000 are both off of my "best" times. Overall, it was "ok" for my first trip down a real track in the L, but couple other lightning guys there were bitching cause the shitty track prep. They said I should expect low 1.9s on my F1s, but instead one of the guys with Nitto DRs only ran 1.94 best tonight. (his best is 1.80 on the DRs 2 wks ago there) That is all.
Frank5L
10-27-2002, 10:29 AM
Bettered 1/8th again, but it doesnt look like anybody visits this forum. I could not get the damn stock pulley to break loose with 4 different allen head tools. They all disintegrated. I ran (again) with stock ol' pullies and the beast put down some damn good times. Only difference was the Bell Tech drop shackles and the Lakewood slappers and some 50degree air (VERY VERY HUMID THOUGH) and still on my F1s
1.902 60'
5.383 330'
8.261@86.47 660'
I'm stoked!!! That had a 12.8 written all over it.
Oh yeah, Shane, I put some ET Streets on it (26x10.5x16 gotta clear the rear rotors) And it went
1.850 60
5.358 330
8.280@84.66 660
It started walking on me and I would need to put more shims in my Lakewoods (I put all the ones I had in it) for the ET streets.
HoustonLX
10-27-2002, 11:37 AM
Way to go Frank!! That is a solid 12 sec pass for sure, and still with the stock pulley. Nice 60' on those F1's too.
Powered by vBulletin® Version 4.1.9 Copyright © 2012 vBulletin Solutions, Inc. All rights reserved.