been a long time

[jeremy mifflin]

well been working on the car for a little over a year this time
total rebuild
thought i would post a few pics

http://www.mustangmods.com/ims/u/3952/10538/241449.jpg
http://www.mustangmods.com/ims/u/3952/10538/243825.jpg
http://www.mustangmods.com/ims/u/3952/13189/256221.jpg
http://www.mustangmods.com/ims/u/3952/13189/256222.jpg
http://www.mustangmods.com/ims/u/3952/13189/256224.jpg

[jeremy mifflin]

http://www.mustangmods.com/ims/u/1152/1645/257821.jpg
http://www.mustangmods.com/ims/u/1152/1645/257822.jpg

[jeremy mifflin]

still have to run the fuel lines
put a trans cooler in
get the right blower belt
have a drive shaft made
hook up rear brake lines
find a fan that will fit
and put the crank suport on ,with the belt driven fuel pump

[Silversnake91]

Looking good Jeremy. I can't wait to see the car making some passes down the track. All that time and hard work will pay off soon enough. Keep at it and keep up the good work.


Mike

[Otis!]

I have to hand it to you Jeremy, you do some nice work! I haven't been able to harass anybody on the turboforums for some time (in and out of the state and coutry for the last couple of months), but sure like seeing what you are up to. Keep up the good work!

O!

[red95gts]

Lookin good!

[Rusman]

Wow that shore is purdy!

Pardon my ignorance of all things not N/A (and quite a bit that is), but what are those red things hanging off the inlet pipe going to the carb?

[maveRick]

.... what are those red things hanging off the inlet pipe going to the carb?

Flux Capacitors.


<-- winner and still champ :darkbeer:

[red95gts]

Wow that shore is purdy!

Pardon my ignorance of all things not N/A (and quite a bit that is), but what are those red things hanging off the inlet pipe going to the carb?

Blow-Off valves. When you are running at high rpm and snap the throttle closed, there is still a column of compressed air inbetween the blower outlet and the closed throttle. Even worse, the throttle snapping shut creates a pressure wave which travels backwards toward the compressor. This can do damage to the compressor and wheel. The blow-off valves are actuated by manifold vac to release that pressure.

[Rusman]

Thanks, D.

[Saleen91]

Very nice!!!

That rear end is bling!

[Redsnk95]

Looks good as always been following your build over on HC50.com

[jeremy mifflin]

thanks guys,,,
loved the car with the 347 in it was going for a lttle more power
might of went to far....now i hope i can just drive it on the street alittle to at least a cruz

[HoustonLX]

might of went to far

No such thing!